Skip to main content
CIVIL Created Edited

[CIVIL] There is an error in the Anchor Evaluation data (item: number of pedestals).

Question

An error message is generated and no Anchor Evaluation is defined, as shown in the figure below.

Answer

The error message occurs when the number of resistance supports defined directionally in Bearing Evaluation does not match the number of resistance supports defined in the "Resistance Support Position Setting" of the Anchor Evaluation Group.

[ Bearing Evaluation Dialog Box ]

[ Anchor Evaluation Dialog Box ]

To prevent user errors in resistance support input, error checks are performed under the conditions you mentioned. If this error message occurs, it's necessary to double-check the directional number of resistance supports defined in the "Resistance Support Position Setting."

0
Was this article helpful?