Skip to main content
GEN Created Edited

[GEN/Design]The Load Combination is KDS, But If the Design Result Sheet has a Different Standard

Qustion

The load combination is KDS, but the design result calculation sheet is applied with KCI code. Why is this?

 

Answer

In ADS, GEN, and SDS, the load criteria and design criteria are separated, and it is possible to try various methods of analyses and design criteria.

Therefore, the load combinations by design criteria and the criteria for performing the design must be set the same.

 

'Results>Combinations' sets the load combination method based on the selected load criteria.

 

'Design>Concrete Design Parameter > Design Code' sets the design criteria

0
Was this article helpful?