Skip to main content
Composite Design Created Edited

Design Position


  • Select the members for which design will be performed and enter check positions. If Design Position is not entered, the program does not perform the design for any member.



From the main menu, select [Design] tab > [Type : Steel Composite Design] > [Design Input Data] group > [Design Position] > [Design Position]



First, select the members in the model and enter the following:


Check Position

I : Design is carried out only for the I-end of the selected member.

J : Design is carried out only for the J-end of the selected member.

I & J : Design is carried out for both I and J-ends of the selected member.

Was this article helpful?