[DESIGN+] 2023 v1.2 Release Note

Enhancements in Design+ 2023 (v1.2)

1) Patch

- Error in the calculation of strength reduction factor in the flexural design as per ACI-14

- Error setting rib No. in base plate design.

Contents Article Map

[GEN] 2025 v1.2 Release Note [nGEN] 2023 v1.1 & DRAWING v280.1 Release Note [nGEN] 2022 v3.1 & Drawing v260.2 Release Note [DESIGN+] 2024 v1.1 Release Note [DESIGN+] 2023 v1.2 Release Note [DESIGN+] 2023 v1.1 Release Note [GEN] 2024 v1.1 Release Note [GEN] 2023 v2.1 Release Note [GEN] 2023 v1.1 Release Note