CAD INFRA-DESIGN Created August 28, 2023 05:00 Edited January 21, 2024 23:44

[CAD ID] Some lines are not visible when printing.

Question

When printing the rebar schedule in CAD INFRA-DESIGN, the Rebar Shape is not visible.

Answer

The plot setting of the corresponding layer may be turned off.

After entering the Layer command, if the plot setting of the rebar layer is set to Off, please change it to On.

Figure 1. Layer Settings

Contents Article Map

[CAD ID] How to create the co-ordinate annotation in CAD ID? [CAD ID] How to edit the co-ordinate annotation in CAD ID? [CAD ID] After integration with CAD INFRA-DESIGN in CIM, point rebars within the visible range are not visible in the CIM Mode [CAD ID] Some lines are not visible when printing. [CAD ID] How to Create 3D PDF Drawings [CAD ID] How to Create a 3D Drawing (Rebar Drawing) [CAD ID] How to Create a 3D Drawing (General Drawing) [CAD ID] How to Create a 2D Drawing (Rebar Drawing) [CAD ID] How to Create a 2D Drawing (General Drawing, General Section) [CAD ID] How to Create a Sheet